Kong TACTICAL LANYARD 23kN LOOP flexible positioning connector product CERTIFIED (CE) in accordance with the EN 354 standard

Manufacturer code: 284SETE07KK

Kong TACTICAL LANYARD 23kN flexible positioning connector product CERTIFIED (CE) in accordance with the EN 354 standard

Positioning lanyard consisting of an elastic band and two connectors sewn on the ends, on one side TANGO equipped with a Double Gate closing system on the other webbing loop.

Equipped with an NFC chip to track the production date and product life cycle.
Load: 23 kN
Minimum length: 80 cm (without connectors)
Maximum length: 115 cm (without connectors)
Weight: 245g

Technical specification of the product in accordance with standard EN 354

Category III Personal Protective Equipment 284.E00 - TACTICAL LANYARD is:
- flexible connecting element with two ends, without adjustable fixing length;
- suitable for use in temperatures down to -30°C;
- certified according to EN 354:2010.

Use:

Example of correct use without or with energy absorber (fig.)

Important:

- appropriate precautions must be taken if the device may strike sharp objects or edges;
- the anchor point must comply with the EN 795 standard and always be in a suitable place above the harness attachment point;
- this device must always be switched on to reduce the risk of failure.

Compliance:

This device is intended for use with:
- connectors complying with the EN 362, EN 12275 standards;
- harnesses complying with the EN 361, EN 813, EN 12277, EN 1497, EN 1498 standards;
- energy absorbers complying with the EN 355 standard.

Warning:

- total length of the entire system (incl. with this device, energy) absorber and connectors) must not be longer than 2 m (Fig.);

- do not connect more than one user to more than one energy absorber (Fig.);
- the device is suitable for connecting only one user (Fig.);
- using this device with a loop can reduce the strength by up to 60% (Fig.);

- special conditions (e.g. heat, cold, moisture, oil, dust) reduce the efficiency of the device;
- the potential fall height must always be less than 0.5 m, unless the user is equipped with appropriate devices (e.g. energy absorbers)
in accordance with the EN 355 standard) protecting against dynamic forces acting on the user during fall arrest.

Checks before and after use:

Before and after use, make sure that the device is working properly.
the technical condition and correct operation should be checked as follows:
- whether the device is suitable for the intended use;
- there are no cuts, melts, chemical residues, excessive pilling, whether there is no visible wear;
- whether there are no signs of UV radiation, in particular, check the areas in contact with metal elements;
- whether the seams are intact and there are no cut or loose threads;
- whether all markings, including labels, are legible, and the expiration date has not expired.

Certificates:

This device has been certified by notified body no. 0123 TÜV SÜD
Product Service GmbH Daimlerstraße 11 - 85748 Garching - Germany

Warranty and product life cycle

The indications regarding the device's service life are determined by KONG S.p.A. in accordance with the requirements of EU Regulation 2016/425. The service life is determined by the type of materials, the construction of the device and its intended use.

The following conditions significantly shorten the service life of the device:

- improper use, intensive use or use in an aggressive environment (salty, extreme temperatures, contact with chemicals)
- storage in conditions other than those specified in the manufacturer's information
- reduced or no maintenance

Use: 2 years of proper storage before use + 10 years from the date of first use (i.e. maximum 12 years from the date of production)

Warranty: 3 years (does not apply to the elasticity of the elastic band)